Commission Regulation (EU) No 1304/2014 of 26 November 2014 on the technical specification for interoperability relating to the subsystem ‘rolling stock — noise’ amending Decision 2008/232/EC and repealing Decision 2011/229/EU Text with EEA relevance

This Regulation lays down the technical specification for interoperability (TSI) relating to the ‘rolling stock — noise’ subsystem of the rail system in the Union, as set out in the Annex.

The TSI shall apply to the rolling stock which falls within the scope of Commission Regulation (EU) No 1302/2014 and Commission Regulation (EU) No 321/2013 .

Within six months of the entry into force of this Regulation, Member States shall notify the Commission of all agreements containing requirements relating to noise emission limits, provided they were not already notified under Commission Decisions 2006/66/EC or 2011/229/EU. The agreements to be notified shall be: (a) national agreements between the Member States and railway undertakings or infrastructure managers, agreed on either a permanent or a temporary basis and necessitated by the specific or local nature of the intended transport service; (b) bilateral or multilateral agreements between railway undertakings, infrastructure managers or safety authorities which deliver significant levels of local or regional interoperability; (c) international agreements between one or more Member States and at least one third country, or between railway undertakings or infrastructure managers of Member States and at least one railway undertaking or infrastructure manager of a third country which deliver significant levels of local or regional interoperability.

The procedures for assessment of conformity, suitability for use and EC verification set out in Section 6 of the Annex to this Regulation shall be based on the modules defined in Commission Decision 2010/713/EU .

1 With regard to the specific cases listed in Section 7.3.2 of the Annex, the conditions to be met for the verification of interoperability in accordance with Article 17(2) of Directive 2008/57/EC shall be the applicable technical rules in use in the Member State which authorises the placing in service of the subsystems covered by this Regulation.

2 Within six months of the entry into force of this Regulation, each Member State shall inform the Commission and the Member States about: (a) the technical rules referred to in paragraph 1; (b) the conformity assessment and verification procedures to be carried out in application of the technical rules referred to in paragraph 1; (c) the bodies designated in accordance with Article 17(3) of Directive 2008/57/EC in order to carry out the conformity assessment and verification procedures with respect to the specific cases set out in Section 7.3.2 of the Annex to this Regulation.

Compliance with the lower exposure action values set out in Article 3 of Directive 2003/10/EC of the European Parliament and of the Council shall be ensured by compliance with the driver's cabin interior noise level, as set out in point 4.2.4 of the Annex to this Regulation as well as by appropriate operational conditions to be defined by the railway undertaking.

1 In order to adapt to technological progress, innovative solutions may be proposed by the manufacturer or its authorised representative which do not comply with the specifications set out in the Annex and/or for which the assessment methods set out in the Annex cannot be applied.

2 Innovative solutions may be related to the rolling stock subsystem, its parts and its interoperability constituents.

3 Where an innovative solution is proposed, the manufacturer or his authorised representative established within the Union shall state in what way it deviates from or how it complements the relevant provisions of this TSI and shall submit the deviations to the Commission for analysis. The Commission may request the opinion of the Agency on the proposed innovative solution.

4 The Commission shall deliver an opinion on the proposed innovative solution. If this opinion is positive, the appropriate functional and interface specifications and the assessment method, which need to be included in the TSI in order to allow the use of this innovative solution, shall be developed by the Agency and subsequently integrated into the TSI during the revision process pursuant to Article 6 of Directive 2008/57/EC. If the opinion is negative, the proposed innovative solution shall not be used.

5 Pending the review of the TSI, a positive opinion delivered by the Commission shall be considered as an acceptable means of compliance with the essential requirements of Directive 2008/57/EC and may therefore be used for the assessment of the subsystem.

The declaration of verification and/or conformity to type of a new vehicle established in accordance with Decision 2011/229/EU shall be considered valid: for locomotives, EMUs, DMUs and coaches until the type or design certificate needs to be renewed as stated in Decision 2011/291/EU for cases where the latter decision was applied, or until 31 May 2017 for other cases, for wagons until 13 April 2016. The declaration of verification and/or conformity to type of a new vehicle established in accordance with Decision 2008/232/EC shall be considered valid until the type or design certificate needs to be renewed as stated in this Decision.

1 Decision 2011/229/EU is repealed with effect from 1 January 2015.

2 In the Annex to Decision 2008/232/EC, points 4.2.6.5, 4.2.7.6 and 7.3.2.15 are deleted with effect from 1 January 2015.

3 The provisions referred to in paragraphs 1 and 2 shall however continue to apply in relation to projects authorised in accordance with the TSI annexed to those Decisions and, unless the applicant requests to apply this Regulation, to projects relating to new vehicles and to the renewal or upgrading of existing vehicles which are at an advanced stage of development, are the subject of a contract in force on the date of publication of this Regulation or cases referred to in Article 8 of this Regulation.

This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union. It shall apply from 1 January 2015. However, an authorisation for placing into service may be granted in application of the TSI as set out in the Annex to this Regulation, before 1 January 2015.