Commission Regulation (EU) No 493/2012 of 11 June 2012 laying down, pursuant to Directive 2006/66/EC of the European Parliament and of the Council, detailed rules regarding the calculation of recycling efficiencies of the recycling processes of waste batteries and accumulators Text with EEA relevance

This Regulation shall apply to the recycling processes carried out to waste batteries and accumulators from 1 January 2014.

For the purposes of this Regulation, the following definitions shall apply: (1) ‘recycling process’ means any reprocessing operation as referred to in Article 3(8) of Directive 2006/66/EC which is carried out on waste lead-acid, nickel-cadmium and other batteries and accumulators and results in the production of output fractions as defined in point 5 of this Article. The recycling process does not include sorting and/or preparation for recycling/disposal and may be carried out in a single facility or in several facilities; (2) ‘preparation for recycling’ means treatment of waste batteries and/or accumulators prior to any recycling process, which shall, inter alia, include storage, handling, dismantling of battery packs or separation of fractions that are not part of the battery or accumulator itself; (3) ‘recycling efficiency’ of a recycling process means the ratio obtained by dividing the mass of output fractions accounting for recycling by the mass of the waste batteries and accumulators input fraction expressed as a percentage; (4) ‘input fraction’ means the mass of collected waste batteries and accumulators entering the recycling process as defined in Annex I; (5) ‘output fraction’ means the mass of materials that are produced from the input fraction as a result of the recycling process, as defined in Annex I without undergoing further treatment, that have ceased to be waste or that will be used for their original purpose or for other purposes, but excluding energy recovery.

1 The method set out in Annex I shall be used to calculate the recycling efficiency of a process for recycling waste lead-acid, nickel-cadmium and other batteries and accumulators.

2 The method set out in Annex II shall be used to calculate the rate of recycled lead content for any recycling process.

3 The method set out in Annex III shall be used to calculate the rate of recycled cadmium content for any recycling process.

4 Recyclers shall report the information shown in Annex IV, Annex V and Annex VI, as applicable, on an annual basis and shall send it to the Member State’s competent authorities by no later than four months from the end of a calendar year concerned. Recyclers shall send their first annual reports no later than the 30 April 2015.

5 Reporting on the recycling efficiency shall cover all individual steps of recycling and all corresponding output fractions.

6 Where a recycling process is carried out at more than one facility, the first recycler is responsible for submitting the information required under point 4 to the Member State’s competent authorities.

This Regulation shall enter into force on the day of its publication in the Official Journal of the European Union.